Description
New Trans Tunnel for your 1965-1973 Ford Mustang! We made it easier for anyone to install as we have done the hard work for you. This is not a generic universal piece–we designed our transmission panel to be as compact as possible and will allow the use of the stock consoles.
This panel is designed to raise the stock tunnel up to 1-1/2” above the stock height. It is not intended to repair tunnels with big holes cut in them, however it is part of good plan to achieve proper driveline angles with the installation of late model engines and transmissions.
Front width 12.5
Rear width 8.25
Length 29.5
It is a very nice design that does not require difficult fabrication. It requires a minimal amount of factory tunnel removal without reducing the strength of the stock floor if properly installed.
